Asus PCI-DA2100 User Manual page 142

Appendix A
adapter and thus no logical drives or devices should be
mapped to this SCSI ID.
4. Make sure the RAID configuration is properly set. (Refer to
chapter 8, ASUS Text RAID Manager User Interface, for more
information on configuring RAID).
5. Follow the instructions in the NetWare User's Manual to install
the server.
6. Run the NetWare v3.11 or v3.12 SERVER.EXE program to start
the server.
7. At the system console prompt, use load command to load the
ASUS PCI-DA2100/-DA2200 driver by typing load da2000.dsk
[Enter]
8. System console will display the following messages on the
screen:
Loading module DA2000.DSK
ASUS PCI-DA2100/-DA2200 Disk Driver for NetWare v3.1x
Version x.xx
Auto-loading module DAASPI.DSK
DA ASPI Manager for NetWare v3.1x, v4.0x and v4.1
Version x.xx October 27, 1995
Supported Slot values are 11
Slot: 11
The slot number(value) is auto-detected by the ASUS PCI-
DA2100/-DA2200 driver according to which PCI slot the ASUS
PCI-DA2100/-DA2200 has been plugged into. Write down the
slot number for later using in STARTUP.NCF.
9. At this point, press [Enter]. If the ASUS PCI-DA2100/-DA2200
driver installs successfully, the system console will display the
following messages on the screen:
PCI Bus # = 0, Device # = 9, Port = E400, IRQ = 10
DA2000 Disk Driver Installed Successfully
142
November 3, 1995
ASUS PCI-DA2100/PCI-DA2200 User's Manual