Table of Contents
Advertisement
(5) Installation of controller
Open the ejectors of the controller, insert the controller into the slot to the end
securely. (The lock of the protection shutter closed when the controller was pulled
out is automatically released by inserting the controller.)
Insert the controller as far as it will go, and close the ejector.
Strongly push the ejector (the part indicated by the arrow in the figure) until the
controller is inserted firmly, and secure the ejector with the screw.
When inserting the controller into the array controller, push it as far as it
will go and then secure it with the screws.
Incorrect insertion may cause malfunction.
77
Advertisement
Table of Contents
