13.
Dynamic Data Replication
This feature creates the replication of a logical disk in a single unit. To create the
replication, the source logical disk must have the same capacity as the destination disk.
To use this feature, the specific software NEC Storage DynamicDataReplication sold
separately is required. Refer to the manual provided with the software.
Before the Dynamic Data Replication can be used on this disk array unit, the license key
provided with the software must be entered from "NEC Storage Manager" in order to
release the license lock.
You can release the license lock and make settings by yourself.
NEC maintenance service representative provides the installation service (additionally
charged) for releasing the license lock and making settings. Contact your maintenance
service representative if necessary.
14.
Miscellaneous Settings
Miscellaneous information shown below can be set by using the management software
(NEC Storage Manager):
• Time in disk array
• Rank bind/unbind
• Logical disk bind/unbind
• Change of ownership of logical disk
• Hot spare settings
• Change of repair time
See "Guide to Setting of NEC Storage Manager Configuration" for the above settings.
The time in disk array is set at system activation by the time synchronization among
controllers.
15.
Various Default Values
Cross call
Auto assignment
Expand LUN
Auto repair mode
Hot spare mode
1-BBU cache enable mode
1-CNT cache enable mode
Access control
Dynamic Data Replication
Off
Off
Off (Peripheral device addressing)
On
On (Level-b0: restoration executed)
On
Off
Off
Off
131