Configuring The Printer For Ipx - NEC SuperScript 1800 Network User's Manual

4. Press ITEM until
CFG ADDRS
5. Do one of the following.
• If you plan on having a BOOTP or RARP server
assign an IP address to the printer, press VALUE
until appears.
NO
a. Then press SELECT.
b. Press ITEM until
c. Press VALUE until
d. Press SELECT.
e. Press GO to exit.
f. Restart the printer.
• If you want to enter an IP address, press VALUE
until appears.
YES
a. Then press SELECT.
b. Press ITEM until
c. Press VALUE until
d. Press SELECT.
e. Press VALUE until the first octet of the IP
address appears.
f. Press Select.
g. Repeat Steps "B" through "F" for IP BYTE2,
IP BYTE3, and IP BYTE4.
h. If you want to configure a subnet mask and/or
gateway (router) address, press ITEM to move to
the SM BYTE and GW BYTE menus, then use the
same procedures as described above.
i. Press GO to exit.
appears.
or appears.
BOOTP RARP
appears.
YES
appears.
IP BYTE1
appears.
YES
Configuring the Printer for IPX
If the printer will be communicating through a NetWare
network, use this procedure for turning on IPX and selecting
the type of Ethernet framing used by the network. The
printer can be configured to determination the framing
automatically, or set to use a specific type.
To configure IPX protocols:
1. From the printer's Operator Panel, press GO until
appears on the Operator Panel display.
OFFLINE
2. Press MENU until
NETWORK MENU
3. Press ITEM until
CFG NET
4. Press VALUE until
YES
5. Press SELECT.
6. Press ITEM until
NetWare
7. Press VALUE until
YES
8. Press SELECT.
9. Press ITEM until
CFG NWAR
10. Press VALUE until
YES
11. Press SELECT.
12. Press ITEM until
AUTO
13. Do one of the following.
• If you want the printer to automatically determine
the type of Ethernet framing used by your network,
press VALUE until
may slow down the processing of print jobs.
a. Then press Select.
b. Press GO to exit.
• If you know what type of Ethernet framing is used
by your network, press VALUE until
Using this method may speed up the processing of
print jobs.
a. Then press SELECT.
b. Press ITEM until your frame type appears.
Framing for Ethernet 802.2, 802.3, II, or SNAP
can be selected.
c. Press VALUE until
d. Press GO to exit.
appears.
appears.
appears.
appears.
appears.
appears.
appears.
appears.
appears. Using this method
ON
appears.
OFF
appears.
YES
Configuring the NIC 13