NEC SuperScript 1800 Network User's Manual page 50

Command Description
IP BYTE n Use this command for configuring a static IP
address for the NIC. The letter n indicates which
octet of the address is currently being viewed or
configured.
Use the ITEM button to navigate between octets.
Use the VALUE button to select a number for a
specific octet.
SM BYTE n Use this command for configuring a subnet mask
for the IP address. The letter n indicates which
octet of the address currently being viewed or
configured.
Use the ITEM button to navigate between octets.
Use the VALUE button to select a number for a
specific octet.
GW BYTE n Use this command for configuring a gateway IP
address. The letter n indicates which octet of the
address currently being viewed or configured.
Use the ITEM button to navigate between octets.
Use the VALUE button to select a number for a
specific octet.
LPD If set to YES, the NIC will accept print jobs from
UNIX computers running LPR software.
APL TALK If set to YES, the NIC will accept print jobs from
Macintosh computers.
NETWARE If set to YES, the NetWare commands can be
navigated.
CFG NWAR If set to YES, the NetWare IPX/SPX protocols will
be accepted by the NIC.
AUTO If set to YES, the NIC will read the header of each
Ethernet frame to determine which type of
framing is being sent to the printer from your
NetWare network.
Use Auto if you don't know which framing is
being used, however, this will be at the expense
of slower processing time by the NIC.
EN_8023 Set to YES if your NetWare network is
communicating with Ethernet 802.3 framing.
EN_II Set to YES if your NetWare network is
communicating with Ethernet II framing.
EN_8022 Set to YES if your NetWare network is
communicating with Ethernet 802.2 framing.
44 SuperScript 1800 — Network User's Guide
Command Description
EN_SNAP Set to YES if your NetWare network is
communicating with Ethernet SNAP framing.
UPDATE Set to YES if you are going to update the NIC
firmware. See Appendix E, "Upgrading the NIC
Firmware, " on page 73 for more information.
BOOT SVR Set to WINDOWS if upgrading the NIC firmware
from Windows 95 computer.
Set to UNIX if upgrading the NIC firmware from
UNIX computer.
SV-IP Bn Use this command for configuring an IP address
for the computer that will be updating the NIC
firmware. The letter n indicates which octet of the
address is currently being viewed or configured.
Use the ITEM button to navigate between octets.
Use the VALUE button to select a number for a
specific octet.
FACTORY Set to YES if you want to configure the NIC using
the NIC default values.
DEFAULT
This can be used as a method for cleaning up the
NIC. If the default values are applied, you must
still reconfigure the NIC so that it can
communicate with your network.
PRINT Set to YES if you want to print out a page that
describes the settings applied to the NIC.
NET CFG