Dtmf Receiver Check; Operation At Extension; To Remove Dtmf Receiver - Panasonic EASA-PHONE KX-T30810 Installation Manual

To set
-_..__....~.----...---...
until the desired
DTMF
receiver appears
[28] [NEXT] [SELECT] [MEMORY] [END]
To confirm
Dial any extension (e.g.. . .12) and listen to ring
of
that extension.
DTMF (Dual Tone Multi Frequency) Receiver
Confirmation of DTMF Receiver 1:
enables tone telephones to dial within the
system.
TO check the DTMF Receivers, activate the
DTMF Receivers one at a time and confirm if
the receiver can receive tone signals.
em sio
To Remove DTMF Receiver 2:
1. Set the System Program Switch to the
PROGRAM position.
2. Dial (28) to enter the DTMF mode.
"DTMF RCVR SEL" will be displayed.
3. Press the NEXT button, twice.
"DTMF 1: ENABLE" and then
"DTMF 2: ENABLE" will be displayed.
.
Press the SELECT button to change to
DISABLE.
"DTMF 2: DISABLE" will be displayed.
5. Press the MEMORY button.
6, Press the END button to return to the initial
program mode.
.
Set the DIALING MODE (located on the
rear
of
KX-T30830) switch to the TONE
position.
2. Set the POWER FAILURE (located on the
rear
of
KX-T30830) switch to the ON
position.
3. Dial the extension number (e.g. . ..12).
If
DTMF Receiver is bad, do the following
procedure for removing the DTMF Receiver
after the next step on this section.
5. Set the POWER FAILURE Switch to the
OFF position.
To check the DTMF Receiver 2, remove DTMF
Receiver 1 and confirm that DTMF Receiver 2 is
good by the procedures
of
"To Remove DTMF
Receiver 1" and "Confirmation
of
DTMF Receiver
2".
The "DISABLE" can not be established on
both DTMF Receivers 1 and 2, at the same
time.
7. Set the System Program Switch to the SET
position.
5-4