Installation; To Mount On The Wooden Wall - Panasonic EASA-PHONE KX-T30810 Installation Manual

Avoid installing in the following places. (Doing so may result in malfunction, noise, or discoloration.)
. In direct sunlight and hot, cold, or humid places. (Temperature range: 32"F-104°F)
~ Sulfuric gases produced in areas where there are thermal springs, etc. may damage the equipment or
contacts.
. Piaces in which shocks or vibrations are frequent or strong.
. Dusty places, or places where water or oil may come into contact with the unit.
5. Near high-frequency sewing machines or electric welders.
. On or near computers, telexes, or other office equipment, as well as microwave ovens or air conditioners.
(It is preferable not to install in the same room with the above equipment.)
. Near radio broadcast antennas (including short wave).
s Install at least 6 feet from radios and televisions. (both the electronic modular switching system and EMSS
proprietary telephones)
. Do not obstruct area around the electronic modular switching system. (for reasons
of
maintenance and
inspection-be especially careful to allow space for cooling above and at the sides of the electronic modular
switching system)
The wall where the KY-T30810 is to be mounted must be able to support a weight of KX-T30810. If screws other
than the ones supplied are used, use the same-sized diameter screws at the enclosed ones.
1. Place the templet (included) on the wall to mark 2. Install the 3 screws into the wall.
-
the 3 screw positions.
zEs.------
-t-
~--- -.--------t-
templet
__
,
Qae------ ---+
ok the unit on the screw heads.