Pulseltone Conversion - Panasonic EASA-PHONE KX-T30810 Installation Manual

When
the dialing mode is required to change a
pulse mode to a tone mode in one dialing
sequence, this feature is used.
(e.g. computer-accessed long distance service)
DIALTHE
PHONE
NUMBER
DIALTHE
PHONE
NUMBER
DIAL"++ #"
When you dial using this feature, you must use
the line selected in a pulse mode.
Phone number after dial "Ji- #" will change to
tone mode.
A rotary phone is not available for the
PulselTone Conversion.
You should press "-3c" and "#" buttons within
10 seconds after the number
of
the long
distance service company.
When you use a standard telephone equipped
with automatic dialer, be careful the follow-
ings:
le: Computer-accessed long distance ser-
vice
Local access telephone number of the alternate
long distance service company 76.5-4321,
Authorization no.0123456,
Long distance no. 543-210-9876
Pulse mode is required by local access tele-
phone number of the alternate long distance
Service company.
Service
of
MCI, SPRINT, METRO or other
systems is used.
Set to PULSE Switch to TONE
L-J
Tone mode
Store the long distance service company no.
in PULSE mode, and switch to the TONE
mode to memory the following numbers.
4-7
ting" (through built-in speaker) that
is established at the called party's extension, can
e switched to " Tone alterting " (ringing).
This
feature
required to be
set
beforehand in
the KX-T30810. For programming, see page
tary phone is not available.
Switching to Tone Alerting
WAITUNTILA
CONFIRMATION
TONEISHEARD
PRESS"?+"
RING BACK
TONE
You should press I'*" button within 10
seconds after the dialing.