Disconnect Time - Panasonic EASA-PHONE KX-T30810 Installation Manual

,...._______________.
A= [ -tc]: to assign the sume on all 3 CO's
~~
until the desired disconnect time appears
.~I
[19] [NEXT] [k] [SELiCT] [MEMORY] [END]
;9] [NEXT] [NEXT] [SELECT] [MEMORY][END]
--.--- until the desired CO rlumber appears
esc
A certain amount
of
time is needed
for
a outside
call to be released, this is necessary so that new
calls may be attempted after disconnecting with
the previous calls.
There are two choices available, 1.5 and 4.0
seconds.
6. Repeat steps 3 to 5, to set the disconnect time
.for the
other CO's.
7. To return to the initial program mode, press
the END button.
The time you select must be longer than the
requirements from your Central Office or host
PBX.
s
d. Dial (19).
"DISCONNECT TIME" will be displayed.
2. Press the NEXT button.
"ENTER CO NO" will be displuyed.
3. Press the NEXT button.
"CO 1: 1.5 SEC" will be displayed and
"1.5 SEC" will blink.
L(
start the programming from step 1,
you may dial the desired CO number instead
of
the NEXT button at step 3.
The PREV button allows you to go to the
previous CO
for
displaying the disconnect
time.
4.0
set on
all 3 CO=
[19] [NEXT] [x] [SELECT] [MEMORY] [END]
.
Press the SELECT button to alternate be-
tween 1.5 set and 4.0 sec.
See pqe 5-16.
5. Press the MEMORY butto,l.
The blinking LCD will stop.