NEC Express5800/320Fd-LR User Manual page 417

On-screen error message
0BA0 SDR/PIA mismatched.
SDR, PIA must be
updated.
0BB0 SMBIOS - SROM data
read error
0BB1 SMBIOS - SROM data
checksum bad
0BC0 POST detected startup
failure of 1st Processor
0BC1 POST detected startup
failure of 2nd Processor
8100 Memory Error detected
in DIMM group #1
8101 Memory Error detected
in DIMM group #2
8102 Memory Error detected
in DIMM group #3
8120 Unsupported DIMM
detected in DIMM group
#1
8121 Unsupported DIMM
detected in DIMM group
#2
8122 Unsupported DIMM
detected in DIMM group
#3
8130 Mismatch DIMM
detected in DIMM
group#1
8131 Mismatch DIMM
detected in DIMM
group#2
8132 Mismatch DIMM
detected in DIMM
group#3
8150 NVRAM Cleared By
Jumper
8151 Password Cleared By
Jumper
8160 Mismatch Processor
Speed detected on
Processor 1
8161 Mismatch Processor
Speed detected on
Processor 2
Cause
SDR and PIA data do not
match.
•
I2C bus is faulty.
•
SROM is faulty.
•
BMC is faulty.
Data within SROM is faulty.
CPU is faulty.
DIMM is faulty.
DIMM is faulty.
DIMM is faulty.
Unsupported DIMM is
mounted.
DIMM group do not match.
CMOS clear jumper is
mounted.
Password clear jumper is
mounted.
CPU frequency does not
match.
Troubleshooting 7-7
Action
If updating SDR/PIA does not
solve the issue, replace ft Remote
Management Card. In the case
ft Remote Management Card is
not mounted, or in the case the
failure still remains after replacing
the card, replace CPU/IO module.
If turning AC power off and on
does not help, replace the system
backboard.
Replace the CPU.
Replace the DIMM Slot0 (2
DIMMs).
Replace the DIMM Slot1 (2
DIMMs).
Replace the DIMM Slot3 (2
DIMMs).
Check supported DIMMs and
replace them. If replacing the
DIMMs does not help, replace the
CPU/IO module.
Turn off the DC power and
change back the jumper setting.
Check supported CPUs and
replace them. If replacing the
CPU does not help, replace
CPU/IO module.