NEC Express5800/320Fd-LR User Manual page 437

Verify the status of the ftSys SSN service by going to [Control Panel] -
[Management Tool] - [Service] and start the Service Manager. If the status is
[Start], there is no problem.
[Detected past event] is recorded
→ Following event is recorded when MSCS is used, then the warning is sent to
ESMPRO/Server Manager
Source:
Event ID:
Description: Cannot get system performance information now (YYYY
- System time is modified.
- System was not shut down properly.
- Event log file is broken.
MSCS has a function which enables to see every event on the computer's cluster
configuration. In some cases, however, events are not stored by date, when such as
shutting down only one side, or launching only one side.
As ESMPRO/ServerAgent checks whether the events are stored by date, any
events out of the date order is shown as "Past Event Detected."
Note that even when this event is recorded, the event log function continues to
function properly for the events stored by date.
Fibre Channel (N8803-035) related log is recorded in the System Event log
→ The below events may be recorded when module switching, including module
failure, occurs. This log indicates that the system has detected a non-fatal,
correctable event for the server operation. This does not affect the system as long
as this event is recorded consecutively.
Source:
Type:
Event ID:
Description: Driver detected control error on \Device\Raid\Port?.
Data: Word
0000: 0018000f 0068001 00000000 c00400b
0010: 0000002a 00000000 00000000 00000000
0020: 00000000 00000000 00000000 00000000
0030: 00000000 c004000b 00000000 00000000
Note 1: "?" indicates the board number.
Note 2: When value is 0x0000002a that is indicated in 0x0010 word.
AlertManagerMainService
802
Code=xxxx).
elxstor
Error
11
Troubleshooting 7-27