SAFETY, NOISE AND VIBRATION PLATES
2.1 SAFETY, NOISE AND VIBRATION PLATES
2.1.1 POSITION OF THE SAFETY PLATES
The safety plates must always be legible and in good conditions; for this reason, if they are dirty with dust, oil or
grease, it is necessary to clean them with a solution made of water and detergent.
Do not use fuel, petrol or solvents.
If the plates are damaged, ask for new ones to Komatsu Utility or to your Komatsu Utility Dealer.
In case of replacement of a component provided with a safety plate, make sure that this plate is applied also on
the new piece.
The machine can be provided with other plates in addition to those indicated below; keep also to the instruc-
tions given in the additional plates, in any case.
MACHINE WITH CAB
RYA11880
20
RWA00020
RWA00010
RWA00030