Detailed Command Descriptions - GE MDS entraNET 900 Technical Manual

Table 4-1. Remote Commands—Quick Reference
COMMAND
_? When entered after a command in this list,
(after a com-
shows detailed information and allowable
mand)
entries.
ALARM Displays current alarm conditions by class.
APLIST
Sets or displays serial numbers of up to 50 APs
with which the Remote can associate.
AUTH Sets or displays the Authorization Key and a list
of authorized features.
COM1 Sets or displays the configuration of the COM1
port (baud rate, data format, buffer size,
inter-packet gap).
COM2 Sets or displays the configuration of the COM2
port (baud rate, data format, buffer size,
inter-packet gap).
CONFIG Shows the dump configuration of all settable
parameters.
DEVICE Sets or displays the device configuration,
including owner, company, and serial number.
DIRECT Sets or displays the configuration for direct
mode operation.
ENCRYPT
Sets or displays the configuration for data
encryption.
ETH Sets or displays the Ethernet port configuration.
HANDOFF Sets or displays the hand-off configuration.
ALARM
05-4055A01, Rev. E
DESCRIPTION

4.5.1 Detailed Command Descriptions

Displays the current alarm conditions by severity level. For each level,
the specific events that caused an alarm are listed, along with a brief
description of each alarm. Alarm levels are:
—All alarm classes
ALL
—Non-persistent information
INFORM
—Minor alarm
MINOR
—Major alarm
MAJOR
—Critical alarm
CRITICAL
Optional argument:
—Displays the hex bit codes for the current alarm condition by
HEX=
class. For each specific event that causes an alarm, the corresponding bit
is set. Event numbers are matched to the appropriate hex code by a
n
relationship of 2 .
MDS entraNET Technical Manual
COMMAND
HELP Lists commands supported for the logged-in
user. See also the
beginning of this table.
LOG Sets or displays the event log information.
LOGIN
Secure log-in. Prompts for the case-sensitive
username and password.
LOGOUT Logs the user off and ends the terminal
session.
MESSAGE Sets the default priority level for message
packets (low, normal, high).
PASSWORD Sets the user log-in password for the user at
the current access level or below.
PROGRAM Performs a checksum verification on one of six
parameters.
VERIFY
RADIO Sets or displays the radio configuration and
status.
REBOOT Restarts the radio firmware.
SLEEP
Sets the low-power operating mode: Sleep or
Shutdown.
STATS Shows radio statistics.
STATTRACKE When enabled (STATTRACKER ON), sends
UDP packets from the Ethernet port on the
R
Remote radio every time a wireless packet is
received.
VER
Displays the current version number.
DESCRIPTION
?
command at the
103