GE MDS entraNET 900 Technical Manual page 118

CONFIG
DEVICE
108
—Sets the console port interface mode.
MODE=<mode>
set to unless the device has been authorized for serial payload. To
DATA
escape from data mode, enter three consecutive + characters to
with at least 100 ms between entries.
—Places
CONSOLE
—Places
DATA
—Places
BSP
—Places
INT_LOOP
—Places
EXT_LOOP
—Sets the inter-packet receive gap size in character
RXDELAYCHARS=
times (1-65535).
—Sets the inter-packet delay in milliseconds (1-65535). The
TXDELAY=
minimum
TXDELAY
setting. When
TXDELAY
measured inter-packet delay can increase up to one dwelltime period
(7, 14, or 28 ms).
Saves or displays the current configuration. The output is in a format
that can be copied back into the command line in order to set the
configuration.
Optional arguments:
—Displays the current configuration. This is a read-only response.
SHOW
—Programs the current configuration into the Factory
SAVE=FACT
Default configuration table. The factory default is used to restore the
configuration when the system detects a data corruption.
Displays the device configuration, and allows setting of the
, and
NAME LOCATION
Optional arguments:
—Displays all settable optional arguments and their current values.
CMD
You can copy this list to a text file as a record of your configuration.
—(read only) Displays the company name.
COMPANY
—(read only) Displays the radio model number.
MODEL
—(read only) Displays the product name.
PRODUCT
—(read only) Displays the software revision ID.
REV
—Sets or displays the owner information (1-40 ASCII
OWNER
characters).
—Sets or displays the radio name (1-40 ASCII characters).
NAME
MDS entraNET Technical Manual
in command-line mode.
COM2
in transparent data mode.
COM2
in Basic Serial Protocol mode.
COM2
in internal loopback mode.
COM2
in external loopback mode.
COM2
setting should be set to two times the
is set to less than twice the
.
cannot be
MODE
COM2
Dwelltime
setting, the
Dwelltime
,
OWNER
05-4055A01, Rev. E