GE MDS entraNET 900 Technical Manual page 125

REBOOT
SLEEP
05-4055A01, Rev. E
Restarts the radio firmware.
Optional arguments:
—Restarts the radio with the active firmware image.
SAME
—Restarts the radio with the inactive image.
OTHER
—Restarts the radio with Application Image 1.
APP1
—Restarts the radio with Application Image 2.
APP2
Sets or displays the low-power operating mode. These modes are
commonly used where power consumption must be kept to a minimum,
such as in solar-powered installations.
Optional arguments:
—Displays all settable optional arguments and their current values.
CMD
You can copy this list to a text file as a record of your configuration.
—Select the level of RS-232 DTR signal used by
DTRSENSE=<low, high>
the endpoint device to wake the radio:
: DTR Active LOW
LOW
: DTR Active HIGH
HIGH
When is set to
WAKE DTR
from the endpoint device.
HANGTIME=<hangtime in ms>
(100–60000) before returning to Low Power mode.
Indicates whether or not the Sleep indicator LED is
INDICATOR=<on|off>—
active.
: Sleep Mode indicator is on.
ON
: Sleep Mode indicator is off.
OFF
—Set the mode as follows:
MODE=<mode>
: Normal operation; the radio does not sleep.
NONE
: Sleep mode is enabled. In this mode, the radio draws less
SLEEP
than 20 mA at 12 V. It can be brought back online (ready to send
data) within 75 ms. Wake-up is accomplished by asserting the
DTR line on the
at the active
COM
Sleep mode also works on the Ethernet interface, except that the
endpoint device must not require Ethernet pulse signals in order
to send data. This mode is similar to a PC Ethernet port "Wake
on data" setting.
MDS entraNET Technical Manual
, the radio will wake on receiving this signal
—Minimum wake time in milliseconds
port, or by the appearance of payload data
COM2
port.
115