Local Serial Configuration Menu - GE MDS entraNET 900 Technical Manual

05-4055A01, Rev. E

3.6.2 Local Serial Configuration Menu

Figure 3-22. COM1/2—Local Serial Configuration Menu
• (
Port Status
port is enabled or disabled to pass payload data.
typically disabled to allow it to be used for console terminal
control.
NOTE: If
is inadvertently enabled, it will become impossible to
COM1
log in using a console terminal connected to the
connector. This problem can be remedied by typing the Hayes
modem-compatible escape sequence of
by . This restores
ENTER
must log in again.
•
Serial Configuration Wizard
the serial ports using a step-by-step process. When the
Wizard is started, you can choose between beginning the
step-by-step process, or simply viewing the current settings
(see Figure 3-23 on Page
MDS entraNET Technical Manual
, )—Defines whether the specified
COM1 COM2
to console terminal mode. You
COM1
—This is a tool for configuration of
58).
is
COM1
COM1
+ + + followed
SHIFT
57