Correcting Alarm Conditions - GE MDS iNET 900 Reference Manual

120
Table 3-5. Alarm Conditions (Alphabetical Order) (Continued)
Alarm Condition Reported
EVENT_REMOTE
EVENT_REPETITIVE
EVENT_ROUTE_ADD
EVENT_ROUTE_DEL
*
EVENT_RSSI
EVENT_RSSI_CAL
EVENT_SDB_ERR
EVENT_SINREM_SWITCH
EVENT_SYSTEM_ERROR*
EVENT_TFTP_CONN
EVENT_TFTP_ERR
* Condition may be corrected, and alarm cleared, by user.

3.6 Correcting Alarm Conditions

View Event Log on Page 90
(See
Table 3-6 provides insight on the causes of events that inhibit the unit
from operating, and possible corrective actions. The Event Description
column appears on the
Table 3-6. Correcting Alarm Conditions—Alphabetical Order
Event Log Entry Generating Condition
ADC Failure The ADC always reads the
same value (either high or
low limit)
AP Ethernet Link Monitor will check state of
Ethernet link and set alarm if
it finds the link down
Bridge Down When the Bridge fails to be
initialized
Flash Test Failed Internal check indicates
corruption of Flash memory
FPGA Failure Communication lost to the
FPGA
iNET Series Reference Manual
Event Log Entry
Remote Added/
Removed (AP only)
The previous event is
occurring repetitively
Manual entry added to
Routing table
Manual entry deleted
from Routing table
RSSI Exceeds
threshold
RSSI Not Calibrated
Internal
Remote/Endpoint
database error (AP
only)
Eth/Serial mode switch
in a Single Remote
System Error Cleared;
Please Reboot
TFTP connectivity
achieved
Attempted TFTP
connection failed
)
screen.
Event Log
SNMP Trap
eventRemote(66)
--
routeAdded(68)
routeDeleted(69)
rssi(11)
rssiCal(9)
sdbError(80)
sinRemSwitch(70)
systemError(16)
tftpConnection(73)
tftpConnFailed(79)
Clearing Condition
or Action
Contact factory Technical
Services for assistance
Ethernet link is re-established
Contact factory Technical
Services for assistance
Contact factory Technical
Services for assistance
Contact factory Technical
Services for assistance
05-2806A01, Rev. J