Configuring For Ppp Mode - GE MDS iNET 900 Reference Manual

05-2806A01, Rev. J
•
Seamless Inter-Frame Delay
sent the end of a message (inter-character time-out). MOD-
BUS defines a "3.5-character" parameter. [
•
Custom Data Buffer Size
mum amount of characters, that the Remote end will buffer
locally before starting to transmit data through the serial port.
[
16, 32, 64, 128, 256; 32
•
Commit Changes and Exit Wizard
made on this screen (Shown only after changes have been
entered.)

2.6.5 Configuring for PPP Mode

• —Enable/Disable the serial data port.
Status
• —PPP. This is the type of IP port that will be offered
IP Protocol
by the transceiver's serial device server. [
•
Device IP Address
device once the connection is established. [
• —The baud rate of the serial port of the transceiver to
Data Baud
which the external device is connected.
[
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200; 19200
• —Byte format of the serial port
Configuration
[
7N1, 7E1, 701, 7N2, 7E2, 702, 8N1, 801, 8N2, 8E2, 802; 8N1
• (COM2 only)—RTS/CTS handshaking between the
Flow Control
transceiver and the connected device.
[
Enable, Disable; Disabled
• —When seamless mode is selected, data bytes will be
Serial Mode
sent over the air as quickly as possible, but the receiver will
buffer the data until enough bytes have arrived to cover worst
case gaps in transmission. The delay introduced by data buffer-
iNET Series Reference Manual
— Number of characters that repre-
(Custom Packet Mode only)—Maxi-
]
—Save and execute changes
Invisible place holder
Figure 2-36. PPP Menu
—IP address that will be assigned to the dialing
]
]
1–65,535; 4
]
TCP, UDP, PPP; TCP
]
0.0.0.0
]
]
71