Channel Config Menu - GE MDS iNET 900 Reference Manual

05-2806A01, Rev. J
• : 902–928 MHz band
ISM
• : 915–928 MHz band
GSM
• : 902-907.5 and 915-928 MHz bands
SPLIT
• : 902–928 MHz, individual channels selectable
CHANNELS
within this range
•
(Only applies to iNET. Editable at AP Only.)
Skip Zones
brings up a submenu discussed in Skip Zones Menu on Page 56.
•
Auto Data Rate Configuration
as shown in Figure 2-29. For the settings in this submenu to
have any effect, the Data Rate menu item (Page 52) must be set
to .
AUTO

2.5.2 Channel Config Menu

The Channel Configuration menu displays the utilization of channels in
the 902–928 MHz range. This selection is available only on iNET-II or
specially provisioned iNET units. The radio hops only on the channels
selected in this menu.
Figure 2-27. Channel Config Submenu
Key to channel indicators:
(no) = Radio channel is not used
n
(yes) = Radio channel is used
y
(not available) = Radio channel is not available
NA
• —This command clears all entries in the Channel
Clear All
Config Menu, resetting the available channels to "no usage."
Channels that are not available for use will appear with a
notation of or
of pre-existing conditions, and are not user-configurable.
iNET Series Reference Manual
—This selection brings up a submenu
Invisible place holder
. These channels are not available because
NA
—This selection
55