Combined Serial And Ip Application Example - GE MDS iNET 900 Reference Manual

05-2806A01, Rev. J
UDP to the Remote. Upon receiving the packet, the Remote strips the
data out of the UDP packet and sends it out its
presented at the Remote's
Point, stripped, and sent out the Access Point's
configuration does not use multicast addressing.
192.168.0.10
EIA-232
Terminal
or Computer
Figure 2-40. Point-to-Point Serial-to-Serial Application Diagram
Table 2-3. Serial Port Application Configuration
Transceiver Location
1
Access Point (COM2)
1
Remote Unit (COM2)
1. Either COM port can be used, but they must be the same ones at both ends
of the link. Both COM ports can be used simultaneously for two independent
data channels.

2.6.9 Combined Serial and IP Application Example

Note that in this example, the TCP mode does not involve the Access
Point. Thus, the transceiver in a single network can run in both modes at
the same time. In other words, some Remotes can be configured for TCP
iNET Series Reference Manual
port is packetized, sent to the Access
COM
Invisible place holder
192.168.0.1
Access Point
Menu Item Setting
Status Enabled
Data Baud Rate 9,600 (Example)
Flow Control Hardware (Example)
Serial Mode Seamless
SIFD 4
IP Protocol UDP
Remote IP 192.168.0.2
Address (IP address of the Remote radio)
Remote IP Port 30011
Local IP Port 30011
Status Enabled
Data Baud Rate 9,600 (Example)
Flow Control X-ON/X-OFF (Example)
Serial Mode Seamless
SIFD 4 (Characters)
IP Protocol UDP
Remote IP 192.168.0.1
Address (IP address of the AP)
Remote IP Port 30011
Local IP Port 30011
port. Likewise, data
COM
port. Note, this
COM
192.168.0.2
EIA-232
RTU
Remote
75