Network Interface Configuration Menu - GE MDS iNET 900 Reference Manual

05-2806A01, Rev. J
•
Ethernet Port Configuration
tus of the Ethernet port (enabled or disabled), the Ethernet rate
limit, link hardware watch (enabled/disabled), and the Ethernet
link poll address. Detailed explanations of this menu are con-
tained on Page 45.
•
DHCP Server Configuration
services by the Access Point unit. DHCP provides "on-the-fly"
IP address assignments to other LAN devices, including MDS
iNET 900 units. See "DHCP Server Configuration" on Page 46
for more information. [
•
SNMP Agent Configuration
parameters. See "SNMP Agent Configuration" on Page 48 for
more information.
•
Rem-to-Rem bridging
Point radios. When this option is disabled communication can
only happen from Remote to Access Point. This setting prevents
a PC connected to one Remote radio to access a network con-
nected to a different Remote within the same AP realm. [
disabled; enabled
•
Prioritized AP Configuration
Remotes. It allows the definition of a Primary AP to which a
Remote radio should be connected. See "Prioritized AP Config-
uration Submenu" on Page 50 for more information.
•
Ethernet Address
unit's Ethernet interface.
•
Wireless Address
unit's wireless Ethernet interface.

2.4.2 Network Interface Configuration Menu

Because iNET-II and iNET radios support 802.1Q VLAN, the method
for configuring the IP address of a radio may vary depending on whether
the VLAN Status option is enabled or not.
Figure 2-15. Network Interface Configuration Menu
iNET Series Reference Manual
—Presents a menu for defining the sta-
—Menu for configuration of DHCP
]
Disabled
—Contains SNMP configuration
—This option is only available on Access
]
—This option is only available on
(Display Only)—Hardware address of the
(Display Only)—Hardware address of the
Invisible place holder
enabled,
39