Dgs-1210-10P; Front Panel; Rear Panel; Dgs-1210-20 - D-Link DGS-1210-10P Reference Manual

1 Product Introduction
In addition, users can utilize the SNMP MIB (Management Information Base) to poll the switches for
information about the status, or send out traps of abnormal events. SNMP support allows users to integrate
the switches with other third-party devices for management in an SNMP-enabled environment. D-Link Web
Smart Switches also come with the D-View plug-in module that works with D-View 6 SNMP Management
Software, and provides easy-to-use graphic interface and facilitates the operation efficiency.

DGS-1210-10P

8-Port 10/100/1000Mbps plus 2 combo ports of 1000Base-T/SFP ports Web Smart PoE Switch.

Front Panel

Power LED : The Power LED lights up when the Switch is connected to a power source.
Pwr Max: The Pwr Max LED lights up when the Switch reaches the maximum power budget defined by the
administrator via PoE System Settings page of Web GUI or the default power budget of 78 Watts.
Reset: By pressing the Reset button for 5 seconds, the Switch will change back to the default configuration
and all changes will be lost.
Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes.
Port Link/Act/Speed LED (1-8, 9T, 10T 9F, 10F): When mode LED lights up in Link/Act mode, the port
LEDs indicate a network link through the corresponding port. Blinking indicates the Switch is either sending
or receiving data to the port. When the port LED glows in amber, it indicates the port is running on 10M or
100M. When the port LED glows in green, it is running on 1000Mbps.
Port PoE LED (1-8): When mode LED lights up in PoE mode, the port LEDs indicate powering status over
the corresponding port. DGS-1210-10P can supply up to 30W on port 1- 4, which are marked with black
background color on front panel, for IEEE802.3at compliance PDs.

Rear Panel

Power: The power port is where to connect the AC power cord.

DGS-1210-20

16-Port 10/100/1000Mbps plus 4 SFP Slot Web Smart Switch.
Figure 1.1 – DGS-1210-10P Front Panel
CAUTION: The MiniGBIC ports should use UL listed Optical
Transceiver product, Rated Laser Class I. 3.3Vdc.
CAUTION: The ITE is to be connected only to PoE networks
without routing to the outside plant.
Figure 1.2 – DGS-1210-10P Rear Panel
D-Link Web Smart Switch User Manual
3
3
SFP ports for optical transceivers