Section 7 Using Softkeys For Programming; Section 8 What The Softkey Display Prompts Mean - NEC SL1000 Programming Manual

SL1000/SL1100
Use this keypad digit ...
3
4
5
6
7
8
9
0
*
#
Clear/Back
Flash
S 7 USING SOFTKEYS FOR PROGRAMMING
ECTION
(This Feature is available for IP Phone Only.) (SL1000)
Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. The
options for these keys will automatically change depending on where you are in the system program-
ming. Simply press the Softkey located below the option you wish and the display will change accord-
ingly.
Pressing the Cursor key Up or Down will scroll between the menus.
S 8 WHAT THE SOFTKEY DISPLAY PROMPTS MEAN
ECTION
(This Feature is available for IP Phone Only.) (SL1000)
When using a display telephone in programming mode, various Softkey options are displayed. These
keys will allow you to easily select, scan, or move through the programs.
1-6
Enter characters : D-F, d-f, 3.
Enter characters : G-I, g-i, 4.
Enter characters : J-L, j-l, 5.
Enter characters : M-O, m-o, 6.
Enter characters : P-S, p-s, 7.
Enter characters : T-V, t-v, 8.
Enter characters : W-Z, w-z, 9.
Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters : + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
_
Program Mode
Base Service OP1
_
Program Mode
Hard Mtnance
When you want to ...
OP2
ISSUE 1.0
Introduction