NEC SL1000 Programming Manual page 30

SL1000/SL1100
Item No.
05
06
Program
07
10
08
09
13
14
15
16
17
18
19
20
2-8
Item
CLIP Information
Based on this setting, the system
includes a Presentation Allowed
(1) or Presentation Restricted (0)
in the Setup message to allow or
deny the Calling Party Number.
Program 15-01-04 must also be
set to 1 if this option is enabled.
Length of Cable
S-point DDI digits
Dial Sending Mode
ISDN Protocol definition
Dial Information Element
ISDN Protocol definition Only
when Dial Sending Mode (10-03-
08) is set for 1 (Overlap Send-
ing).
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is
less than the setting in 10-03-13,
the system considers this as
Loss-Of-Signal and the PRI does
not come up. Note that there are
different values based on the
setting in 10-03-12 for the PRI.
Service Protocol for S-point
Call Busy Mode for S-point
Two B-Channel Transfer for
PRI Service
ISDN Ringback Tone
System can provide ringback
tone, by setting 10-03-17 is set to
1 : Enable.
Type of Number
ISDN Protocol definition.
Select the number type for the
ISDN circuit.
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used
for the ISDN circuit.
Network Exchange Selection
Select the ISDN protocol for the
ISDN circuit
Input Data
0 = No
1 = Yes
0 = Level 1
1 = Level 2
2 = Level 3
3 = Level 4
4 = Level 5
0 - 4
0 = Enbloc Sending
1 = Overlap Sending
0 = Keypad Facility
1 = Called Party Number
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
0 = Keypad facility
1 = Specified Protocol for Aspire system
0 = Alerting
1 = Disconnect
0 = off
1 = on
0 = Disable
1 = Enable
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
0 = Standard (same as NI-2)
1 = reserved
2 = reserved
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7 = NI-2
Program 10 : System Configuration Setup
ISSUE 1.0
Default Note
1
2
0
1
1
2
0
0
0
0
0
0
0