Appendix 3.3 About The Restrictions - Mitsubishi Electric Got 1000 Training Manual

Appendix 3.3 About the restrictions

This section describes the restrictions of the FA transparent function.
Refer to the GOT1000 Series Connection Manual and GT Designer2 Version2 Screen
Design Manual for details on the specifications and cautions in using the FA
transparent function.
(1) GOT interface required to use the FA transparent function
Connect the personal computer, to which GX Developer or any other relevant
software has been installed, to the RS-232 interface or USB interface of the GOT.
When performing the FA transparent function, use either RS-232 interface or USB
interface of the GOT. Using both of them to perform the FA transparent function
concurrently is not allowed.
(2) When mutiple GOTs are bus-connected
When multiple GOTs are bus-connected, the FA transparent function can be used
on each GOT.
However, note that the monitoring performance of each GOT slows down as the
number of monitoring GOTs and personal computers increases.
(3) When the FA transparent function is used in a bus connection
When the FA transparent function is used in a bus connection, the following GX
Developer functions cannot be executed.
Unsupported GX Developer functions
• Remote Reset
• Remote system reset
• Remote RUN
• Remote STOP
• Remote PAUSE
• Remote STEP-RUN
• Remote latch clear
• Write clock data
• Clear malfunction log
RS-232
USB
RS-232
Cable
PC
Appendix 24
Remarks
—
Inexecutable only when
stations/groups has been specified.
all