NEC Barracuda Service Manual page 68

Barracuda PDA Maintenance
2.3.7 PCMCIA Type Ⅱ + Battery Pack Sled
Disassembly
1. Place the PCMCIA Battery Pack Sled upside down.
2. Remove six screws and the cover. (Figure 2-17)
3. Remove three screws and disconnected the Battery cable. (Figure 2-18)
4. Lift up the PCMCIA PCB Board out of the compartment. (Figure 2-19)
Figure 2-17 Remove six screws Figure 2-18 Remove three screws and Figure 2-19 Lift up the PCMCIA
and the cover. disconnected the Battery cable PCB
Reassembly
1. Replace the PCMCIA PCB Board into the compartment and secured three screws. (Figure 2-18)
2. Replace the cover and secured six screws. (Figure 2-17)
67