Fujitsu Brocade 6545 Gen5 Hardware Reference Manual page 28

2
Inserting the Switch Module in the blade server
4. Pull the release lever out completely so the Switch Module can be seated properly in the
5. With the port side facing you and the release lever fully extended, slide the Switch Module into
6. Push the release lever inward until the release latch clicks into place.
You are now ready to insert the SFP+ optical transceivers. For more information, refer to
SFP+ optical transceivers and cables"
NOTE
Be sure to use only Brocade-branded SFP+ optical transceivers. Unapproved products will not be
recognized.
It is recommended that you review the guidelines when handling SFP+ optical transceivers and
cables before you insert the transceivers and attach the cables. Refer to
considerations when handling transceivers and cables"
16
Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server I/O module bay.
the appropriate Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server I/O module bay.
This locks the Switch Module in the Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server I/O
module bay. Locking the Switch Module in the I/O module bay provides power (if the power is
on in the Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server) and activates (powers on) the
Switch Module and the LEDs.
The Switch Module then runs self-diagnostic tests, such as POST.
After the Switch Module is inserted in the Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server,
the physical Ethernet connection is established through the Fujitsu PRIMERGY BX900 S2 or
BX400 Blade Server Management Blade (MMB).
NOTE
Once inserted, the Switch Module can be accessed remotely. Ensure that the Switch Module is
not being modified from any other connection until configuration is complete. Refer to
3, "Configuring the Brocade 6545 16 Gbps FC Switch
configuration.
Module,"for information about
on page 19.
on page 17 for more information.
Brocade 6545 Gen5 16-Gbps FC Switch Module Hardware Reference Guide
Chapter
"Inserting
"Installation and safety
53-1003184-01