Fujitsu Brocade 6545 Gen5 Hardware Reference Manual page 36

3
Methods for setting the IP address
4. Use the following Telnet menu options to change the IP address of the selected Switch Module.
24
a. Enter the following command at the command prompt:
tip /dev/ttyb - 115200
b. When the terminal application stops reporting information, press Enter to display the login
prompt.
c. Enter the user name and password
user name admin
password admin
a. Run the console redirection command.
cd consoleredirection
set consoleredirectionto=cb<SLOT ID>
NOTE
These steps are needed only in the BX400 chassis.
b. Select (3) Console Redirection from the following Console Menu.
--------------------------------
Console Menu
--------------------------------
(1) Management Agent
(2) Emergency Management Port
(3) Console Redirection
(4) TFTP update
(5) Logout
(6) Reboot Management Blade
(7) System Information Dump
(8) Command Line Interface
(9) Account Management
Enter selection: 3
c. Select (1) Console Redirect Connection Blade from the following Console Redirection
Table.
--------------------------------
Console Redirection Table
--------------------------------
(1) Console Redirect Connection Blade
(2) Set Return Hotkey , Ctrl+(a character) : Q
(3) Set Console Redirection Timeout
Enter selection or type (0) to quit: 1
d. Select the location where the switch is installed from the following menu.
-------------------------------------
Console Redirect Connection Blade
-------------------------------------
(2) Console Redirect Connection Blade-2 (Selected:Backup/Restore)
(3) Console Redirect Connection Blade-3
(4) Console Redirect Connection Blade-4
(5) Console Redirect Connection Blade-5
Enter selection or type (0) to quit: 5
You should now be at the switch login prompt.
Brocade Gen5 6545 16-Gbps FC Switch Module Hardware Reference Manual
: 900
53-1003184-01