Fujitsu Brocade 6545 Gen5 Hardware Reference Manual page 55

5. Press the release latch to free the release lever, then gently pull the release lever out from the
6. Slide the Switch Module out from the I/O module bay and set it aside.
7.
8. Insert the SFP+ optical transceivers that you removed in step 4.
9. Reconnect the cables that you disconnected in step 3.
10. Establish a connection to the Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server
Refer to the Operating Manual that comes with your Fujitsu PRIMERGY BX900 S2 or BX400 Blade
Server for more information on removing and replacing the Switch Module.
Brocade 6545 Gen5 16-Gbps FC Switch Module Hardware Reference Manual
53-1003184-01
Switch Module. Refer to Figure
You will feel the Switch Module unseat and move out of the I/O module bay approximately
0.6 cm (0.25 inch).
1 Release lever
2 Release latch
FIGURE 9
Switch Module release lever and latch
Insert the replacement Switch Module in the I/O module bay of the Fujitsu PRIMERGY BX900
S2 or BX400 Blade Server. You must complete this step within 60 seconds.
NOTE
If you are not inserting a replacement Switch Module in the I/O module bay, use a filler blade
to fill the empty slot in order to maintain proper airflow and cooling. Do not leave the slot
empty.
For safety information and instructions, see
on page 19.
For additional information about connecting cables, see
cables" on page 18, and the documentation that comes with the SFP+ optical transceivers to
which the cables have been connected.
Management Module.
Removing and replacing the Switch Module
9.
"Inserting SFP+ optical transceivers and cables"
"Cabling guidelines for fiber-optic
4
43