Selecting The Length Of Jump Stitch Not To Trim - Brother 882-T51 Operation Manual

b Touch to turn off the thread trimming
function.
→ The key will display as
→ The machine will not trim the thread before moving
to the next stitching.
■ Selecting the length of jump stitch
not to trim
When the thread trimming function
on, you can select the length of the jump stitch not
to trim the thread. This function can be turned on or
off during embroidering.
Select a setting from 5 mm to 50 mm in 5 mm
increments.
→ Your customized setting remains after turning the
machine off and on.
Touch or to select the length of jump stitch.
For example: Touch
the machine will not trim a jump stitch of 25 mm or
less before moving to the next stitching.
Note
• If pattern has many trims it is recommended
to select a higher jump stitch trim setting in
order to reduce the amount of excess tails
on backside of fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the
machine will trim. In this case, more jump
stitches remain on the surface of the fabric.
102
.
is turned
to select 25 mm (1 inch) and