Brother 882-T51 Operation Manual page 37

e Pass the thread through thread guide hole
from front side to back.
1 Thread guide hole
f Pass the thread around the pretension disc
as shown in the illustration. Make sure that
the thread is correctly fed into the tension
disc.
1
1 Pretension disc
g Pass the thread through the thread guide
hole towards you as shown in the
illustration.
EMBROIDERING TUTORIAL
h Wind the thread clockwise around the
bobbin 4 or 5 times, as shown in the
illustration.
i Pass the end of the thread through the guide
slit on the bobbin winder seat, and pull the
thread. The cutter will cut the thread.
1 Guide slit (with built-in cutter)
2 Bobbin winder seat
Note
• Be sure to follow the procedure described.
If the bobbin is wound without the thread
being cut with the cutter, when the bobbin
thread runs low, the thread may become
tangled around the bobbin and cause the
needle to break.
j Push the bobbin winding switch to the left,
until it clicks into place.
→ The bobbin winding window will be displayed on
the LCD screen.
1
1 Bobbin winding switch
2
35