Adjusting The Thread Tension; Adjusting The Tension Of The Bobbin Thread - Brother 882-T51 Operation Manual

Adjusting the Thread Tension

The following procedure describes how to adjust the thread tension if the correct thread tension as
described on page 57 was not used. After adjusting the tension of the bobbin thread, adjust the tension of
the upper thread.
Note
• Be sure to check the tension of the bobbin thread each time that the bobbin is changed.
Depending on the bobbin thread type and whether a prewound bobbin is used, the tension of the
bobbin thread may differ. For example, when replacing an empty prewound bobbin with one of the
same type, be sure to check the tension of the bobbin thread and adjust the tension if necessary.
• Be sure to adjust the tension of the bobbin thread before adjusting the tension of the upper thread.
Adjusting the tension of the
bobbin thread
a Tie the included weight to the end of the
thread extending from the bobbin case.
Note
• Different weights are used to adjust pre-
wound bobbins and metal bobbins.
Pre-wound bobbins: Only weight (L)
Metal bobbins: Weight (L) and weight (S)
• If necessary, refer to "Disassembling and
cleaning the tension unit" on page 167 for
reassembling the tension unit.
OTHER BASIC PROCEDURES
b As shown in the illustration, hold the
bobbin case against a smooth vertical
surface.
• If the thread with the weight attached is slowly pulled
out, the thread tension is correct.
c Use the included standard screwdriver to
turn the tension-adjusting screw and adjust
the thread tension.
1 Tension-adjusting screw
2 Tighter
3 Looser
d After making the adjustments, try
embroidering to check the thread tension.
3
91