Installing The Bobbin; Removing The Bobbin Case; Oiling The Machine - Brother 882-T51 Operation Manual

Hide thumbs Also See for 882-T51:
Table of Contents

Advertisement

2. Installing the Bobbin

When the machine is purchased, an empty bobbin case is installed in the hook. You will need to install a
bobbin wound with bobbin thread for embroidering. For precautions concerning the bobbin, refer to
page 26.
Note
• The machine does not indicate how much
bobbin thread is remaining. Before starting
to embroider make sure that there is
enough bobbin thread for the pattern.
• Make sure to clean the bobbin case every
time the bobbin is changed. For details on
cleaning the bobbin case, refer to "Cleaning
the bobbin case" on page 166.

Removing the bobbin case

a
Open the hook cover.
Pull the hook cover toward you.
b
Pull the thread picker toward you.
1 Thread Picker
To gain access to the bobbin case easily, pull the
thread picker toward front.
Memo
• Thread picker is a device that is used to
hold the thread when beginning to
embroider or when trimming the thread.
CAUTION
• The thread picker can only be moved within a
certain range. Do not pull it with extreme
force.
32
c
Grab the bobbin case latch, and remove the
bobbin case.
1 Latch

■ Oiling the machine

After removing the bobbin case, apply oil to the
machine. The race should be oiled. For details on
oiling the machine, refer to "Oiling the machine" on
page 168.
Note
• Put a drop of oil onto the hook once a day
before use.

Advertisement

Table of Contents
loading

Table of Contents