Fujitsu ETERNUS LT260 User Manual page 40

Chapter 2 Operating the Library
2.5 Configuring the Library
• Drive interface
- FC
Fibre Channel
- SAS
Serial Attached SCSI
• (Modified)
When present indicates that a setting has been changed. To apply the changes, click Submit. To reset all
changed fields to their previously saved values, click Undo.
• Pwr
Indicates whether the drive is currently powered on or off.
• Firmware
The version of firmware currently installed on the drive.
• Manufacturer S/N
The serial number assigned to the drive when it was manufactured. Use this serial number when working
with your Service.
• Power On
Checked when the drive is powered on.
Always power off a tape drive before removing it from the library or moving it to a new location within the
library.
• Port configuration (FC only)
Drive port configuration.
- Speed
The currently selected speed. The default is Automatic.
- Port Type
• Automatic
• Loop
Enables selection of the Addressing Mode.
• Fabric
- Addressing Mode
When Port Type is set to Loop, Addressing Mode can be set to Soft, Hard, or Hard Autoselect.
- Loop ID/ALPA
When Addressing Mode is set to Hard, you can choose an ALPA address from the drop down list.
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Panel Operation-
40
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0