Figure 2.37 Uid Led Control; Figure 2.38 Move Robotic To Base Module; Controlling The Uid Led - Fujitsu ETERNUS LT260 User Manual

Chapter 2 Operating the Library
2.6 Maintaining the Library
2.6.9

Controlling the UID LED

The UID LEDs are a pair of blue LEDs — one on the operator panel and the other on the base module controller.
The UID LEDs are useful for identifying the library in a data center. The UID LEDs are operated synchronously
and controlled by the user. From the Maintenance > UID LED Control screen you can see whether the LEDs are
lit, and toggle the status.

Figure 2.37 UID LED control

2.6.10 Moving the Robotic to the Base Module
Before extending a module from the rack, the robotic assembly must return to its park position in the base
module. Under normal circumstances, when the library is powered off using the front power button the robot
automatically parks and locks into the base module behind the operator panel. After powering off the library
and before proceeding with extending a module from the rack, look inside the base module window to verify
that the robotic assembly is behind the operator panel.
If the library did not move the robotic assembly to its park position, you can do so from the Maintenance >
Move Robotic to Base Module screen.

Figure 2.38 Move robotic to base module

FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Panel Operation-
61
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0