Fujitsu ETERNUS LT260 User Manual page 81

Chapter 2 Operating the Library
2.8 Viewing Status Information
■ IPv4 settings
• DHCP
When Enabled, the library requests an IP address from a DHCP server each time the library is powered on.
• Address
IP address in use by the library. If DHCP is enabled, this address was obtained from the DHCP server. When
DHCP is not enabled, the address was configured.
• Netmask
The network mask of the library controller used when DHCP is not enabled.
• Gateway
The gateway used when DHCP is not enabled.
• DNS 1
• DNS 2
■ IPv6 settings
• Stateless
When Enabled, the device will generate an address for itself based on the routing information obtained
from a router advertisement and the MAC address. The device can manage up to five global addresses at
the same time, which can be assigned from different routers.
• Static
When Enabled, the library will use a statically-configured address.
• Address
The IPv6 address when Static Addressing Enabled is On.
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Panel Operation-
81
Copyright 2016 FUJITSU LIMITED P3AM-8802-04ENZ0