ISSUE 5.0
4.1.4 LED Indication
LED indications for the IP4WW-VOIPDB-C1 are listed
page
2-63. Each LED is listed with its associated function and operational status.
LED
ACT
Link activity or data transmission and re-
ception.
LINK1000
1000Base-T link speed indicator
LINK100
100Base-TX link speed indicator.
LINK10
10Base-TX link speed indicator.
ACT
LINK1000
Off
Off
Off
On
On
On
On
Off
Flash
4.2 Installing the CF Card (CFVMS/CFVML)
• Do not remove or install the CPU Card with the power on.
• If Expansion KSU(s) are installed, turn the power on/off in the order of
Expansion 3 KSU (V3.5 or higher), Expansion 2 KSU, Expansion 1 KSU
and then Main KSU.
Hardware Manual
< Bottom View >
Figure 2-87 Location of LEDs
Table 2-19 VOIPDB LED Indications
Function
Table 2-20 Operation of VOIPDB LED Indications
LED
LINK100
LINK10
Flash
Flash
Flash
Flash
Flash
Flash
Flash
Flash
Blinking one by one
Table 2-19 VOIPDB LED Indications on
VOIPDB-C1
board
LINK10
LINK100
LINK1000
ACT
LED Status
On Green
LED lights when link up is completed. LED flash
when data is transmitting or receiving.
On Yellow
Lights up when 1000Base-T link up.
On Red
Lights up when 100Base-TX link up.
On Red
Lights up when 10Base-T link up.
Operation status
Internal Error (Hardware Error)
State of half duplex transmission (Not support)
Please change HUB etc. to full duplex transmission.
The firmware is being updated.
SL1100
Operation status
2-63