Ip4Ww-008E-B1; Ip4Ww-000E-B1; Ip4Ww-4Coidb-B1; Ip4Ww-1Priu-C1 - NEC SL1100 Hardware Manual

SL1100

2.2.2 IP4WW-008E-B1

This 008E card is installed in the 1228M KSU or 1228ME
EXP and provides a total of eight analog ports. The analog
trunk daughter board (4COIDB) can be mounted on this
card.
• Install this card to the expansion card slot at Main/
Expansion KSU.
• One analog trunk daughter board connection.

2.2.3 IP4WW-000E-B1

(This Unit is for Main Software V1.5 or higher.)
This 000E card is an expansion card and installed in the
1228M KSU or 1228ME EXP. Analog trunk daughter board
(4COIDB) can be mounted on this card.
• Install this card to the expansion card slot at Main/
Expansion KSU.
• One analog trunk daughter board connection.

2.2.4 IP4WW-4COIDB-B1

The 4COIDB provides four analog trunk and is mounted on
the 084M, 080E, 008E or 000E card. A total of nine
4COIDBs can be installed per system or three 4COIDBs per
KSU.
• Mount this board onto the 084M, 080E, 008E or 000E
card.
• 1 power failure transfer circuit
*** No Ground Start Trunk Support ***

2.2.5 IP4WW-1PRIU-C1

The 1PRIU is installed in the 1228M KSU or 1228ME EXP
providing for either an ISDN Primary Rate Interface, T1
Interface. A total of two 1PRIUs can be installed per system
or one 1PRIU per KSU.
With SL1100 V1.5 and higher, the 1PRIU can be installed in
the 3rd expansion slot (slots 10,11,12 respectively) in each
cabinet.
• Install this card to the expansion card slot at Main/
Expansion KSU.
• Supports T/S point connection (Hard-switch).
1-6
ISSUE 5.0
Introduction