Installing The Repeater; Troubleshooting Chart; Maintenance; Installing The Ml440 And Ap20 Wireless Dect Telephone - NEC SL1100 Hardware Manual

ISSUE 5.0

6.3.6 Installing The Repeater

Be sure the wall material can hold the weight of the repeater. Never install a
repeater in damaged or decaying wall material.
1. Hold the repeater in its final location, and mark the location of one of the two wall slots along the
top of the repeater.
2. From that mark, measure down approximately 1-1/2 inches (about 38mm), and mark the screw
location.
3. Measure over 2-3/8th inches (about 60mm) and mark the second screw location.
4. At the screw location, use a 3/16ths drill bit to make a pilot hole approximately one inch deep.
5. Place the wall anchor into the pilot hole and tap it gently with a hammer until the anchor is flush
with the wall.
6. Insert the mounting screw into the anchor, leaving approximately 1/4 inch space between the
screw head and the wall.
7. Repeat steps 4~6 for the second mounting screw.
8. Place the repeater over the screw heads and slide it down into place.
9. Connect the repeater to the 120 V AC power outlet.

6.3.7 Troubleshooting Chart

To review common problems and possible solutions, refer to the Cordless DECT Repeater Guide
DTL-RPT-2.

6.3.8 Maintenance

For user maintenance of the repeater, refer to the Cordless DECT Repeater Guide DTL-RPT-2.

6.4 Installing the ML440 and AP20 Wireless DECT Telephone

This section outlines the steps for connecting and mounting the base station, charging the battery, and
powering on the handset.
The following topics are included in this section:
• Connecting the Base Station on page 2-113
• Wall Mounting the Base Station on page 2-115
• Handset and Charger on page 2-116

6.4.1 Connecting the Base Station

Figure 2-162 Base Station Front and Back View on page 2-114
base station.
Hardware Manual
provides a front and rear view of the
SL1100
2-113