ISSUE 5.0
2.
Route the cable through the channel as shown in
page
2-115.
3.
Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the front briefly lights orange and then
turns off while it initializes and connects to the network. After the base station successfully
initializes and connects to the network, the LED lights green and remains steady on.
Table 2-30 Base Station LEDs States and Meanings on page 2-115
LEDs and their meanings.
Color
State
Green
Flickering
Green
Steady on
N/A
Off
Orange
Briefly on
Orange
Flickering
Red
Blinking
Red
Blinking
Red
Flickering
Red
Steady on
6.4.2 Wall Mounting the Base Station
Follow the steps below to mount the base station to a wall.
Hardware Manual
Figure 2-163 Connecting the Base Station
Table 2-30 Base Station LEDs States and Meanings
Stage in base flash memory rewrite at the end of the base firmware update.
All operations normal.
No power in unit
OR
initializing and connecting to the network.
Powering on.
Stage in base flash memory rewrite at the end of the base firmware update.
Factory reset warning. A factory reset has been initiated or is in progress.
No Ethernet connection available
OR
handset registration failed.
Stage in base flash memory rewrite at the end of the base firmware update.
Critical error. Contact technical support.
Figure 2-163 Connecting the Base Station on
provides a list of base station
Meaning
SL1100
2-115