Selecting A Location; Installation Precautions; Connecting The Telephone Cords; Figure 2-125 Connecting Telephone Cords To The Telephone Jack - NEC SL1100 Hardware Manual

SL1100

6.1.1 Selecting a Location

Select a location for the DTL-8R-1 Cordless DECT to avoid excessive heat or humidity. The base unit
of the DTL-8R-1 Cordless DECT can be placed on a desk or tabletop near a standard 120 V AC outlet
and telephone line jack. The base unit can also be mounted on a standard wall plate using the wall
mount adapter. Keep the base unit and handset away from sources of electrical noise (motors,
fluorescent lighting, computers, PC monitor).

6.1.2 Installation Precautions

To ensure optimum performance follow these guidelines.
• Base units must be placed at least 20 feet apart.
• Always place the base unit on top of a desk or on higher shelves. Avoid locations surrounded by
metal surfaces.
• Place the base away from any electrical component such as a PC, monitor and other telephone.

6.1.3 Connecting the Telephone Cords

When connecting the telephone cords, observe the following precautions.
• Never install telephone wiring during a lightning storm.
• Never touch bare telephone wires or terminals unless the telephone line is
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
To connect the telephone cords:
1. Connect the cord from the telephone jack to the Line In on the DTL-8R-1 Cordless DECT.

Figure 2-125 Connecting Telephone Cords to the Telephone Jack

2-88
ISSUE 5.0
Installation