Selecting A Location - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
The number of units which can be used on the system is greatly affected by the
environment. The closer or smaller the area, the smaller the number of units which
can be used. It is recommended to start with three or less. If there are no conflicts
between the telephones, you can try adding additional units (up to five is the
recommended maximum).
When using wireless LAN, keep in mind that although there should not be a problem
with interference from the WLAN, 802.11b and 802.11g both share the same
frequency as the CT-12 telephone. In theory, the CT-12 is a narrow band high power
device but the 802.11b and 802.11g are both wide band low power technologies.
Therefore, the higher power CT-12 could disrupt the low power device and slow the
data network. There are, however, many exceptions to this (for example, if the WLAN
uses a highly directional antenna, higher power relays between buildings, etc.). The
CT-12 cannot lock down channels, unlike the 802.11b and 802.11g.
The CT-12 features include:
2.1
8 - 2
2.4 GHz Cordless Headset Phone
Range of Up to 150'
Six Hours of Talk Time, 80 Hours Standby Time
Audible Low Battery Indicator
Single Line Operation
Ultra-Compact Remote Unit with Belt Clip
Variable Range Volume Control
10 Speed Dial Numbers
Page/Find Feature
Redial/Flash
Mute with Audible Reminder
Talk/Charge/Power Indicator Lights
Built-in Headset Stand
Selecting an Installation Location
Before choosing a location for your new telephone, consider these important
guidelines:
The location should be close to both a telephone jack and continuous power
outlet. A continuous power outlet is an AC outlet which does not have a
switch to interrupt power.
Keep the base and handset away from sources of electrical noise such as
motors or fluorescent lighting.
UNIVERGE SV8100/SV8300
Installing SV8100/SV8300 Cordless Telephones