UNIVERGE SV8100/SV8300
System Hardware Manual
4.
Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5.
Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6.
Carefully pry loose the knockout covering the bottom option
interface (refer to
Knockout).
Knockout
Figure 11-50 Bottom Option Interface Knockout
7.
Using the exposed Bottom Option Interface as a guide, install
the ADA-L UNIT in the bottom of the DTL/ITL multiline terminal.
Push down until left and right tabs are seated (Refer to
11-51 Install ADA-L
Tab
Bottom Option
Interface
8.
Return tilt leg to original position.
9.
Reconnect all cables previously disconnected.
Figure 11-50 Bottom Option Interface
UNIT).
Figure 11-51 Install ADA-L UNIT
Issue 1.0
Bottom Option
Interface
Figure
Tab
11 - 73