NEC Univerge SV8100 System Hardware Manual page 516

Issue 1.0
term ®
D
S 3
ECTION
The D
Technology and is connected in tandem to a Multiline Terminal. The terminal has a
16-digit, 2-line LCD, dial pad, talk key, chan key, hold key, transfer key, conf key,
mute key, vol key, a msg icon, vibrator, and four function keys with red LEDs.
8 - 4
After installing the battery pack in the handset, charge the handset at
least three to five hours before plugging it into the telephone line.
4. Connect the telephone line cord to the TEL LINE jack and the other end
to the AP(R)-L Unit. Refer to paragraph
for detailed instructions for installing the AP(R)-R Unit. This unit can also
be connected using an SLI(4)/(8)-U( ) ETU.
AP(R)-L Unit
Figure 8-3 Connecting the D
to the AP(R)-L Unit
5. Place the power cord so that it does not create a trip hazard or where it
could become chafed and create a fire or electrical hazard.
Observe the following warnings during installation:
Never install telephone wiring during a lightning storm.
Never touch uninsulated telephone wires or terminals unless the
telephone line is disconnected at the network interface.
Use caution when installing or modifying telephone lines.
C II T
ORDLESS
term
Cordless II terminal uses 900 MHz Digital Spread Spectrum (DSS)
Telephone Line Cord
(supplied)
term
Headset Cordless Telephone Cord
ERMINAL
Installing SV8100/SV8300 Cordless Telephones
UNIVERGE SV8100/SV8300
12.4 APR-L UNIT on page 11-75
To TEL LINE