Figure 13-25 Connecting A Multiline Terminal To A Pc Using A Ct(U)-R Unit (Example) - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
ESI
ETU
13 - 24
Figure 13-25 Connecting a Multiline Terminal to a PC using a CT(U)-R Unit
(Example) shows how the CT(U)-R Unit is connected to the ESI(8)-U( ) ETU
and to the PC. The required AC-2R/AC-3R Unit is not shown.
Multiline Terminal + CT(U)-R Unit
Line Cord (2-line)

Figure 13-25 Connecting a Multiline Terminal to a PC using a CT(U)-R Unit (Example)

3.5.1 Installing the CT(U)-R Unit
The CT(U)-R Unit should be installed after the switches are set.
When wall mounting the Multiline Terminal, a WM-R Unit must be used.
Refer to
1. Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page
2. Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to
Multiline Terminal on page
CT(U)-R Unit
Optional Headset
Section 11 Wall Mounting Multiline Terminals on page
13-1.
Figure 13-26 Attaching the CT(U)-R Unit to the
13-25.
Installing D
UNIVERGE SV8100/SV8300
USB Cable
term
Series i Optional Equipment
PC
12-22.