Table 6-56 Ethernet Connector Pin-Out - NEC Univerge SV8100 System Hardware Manual

Issue 1.0
6 - 106
6.1.4.7

Table 6-56 Ethernet Connector Pin-Out

View
PIN1 ---- PIN8
1 8
On the APSU, 5V shall be provided to the VGA connector in
a manner where it can be removed from the connector via
component depopulation to reduce current draw on the 5V
power supply should this feature not be needed.
10/100 BASE-TX Ethernet Interface
The APSU card provides a 10/100 Ethernet interface
through an RJ-45 connector. Some possible uses for the
Ethernet port are the following:
Unified Messaging (Email)
Software Update
Application Configuration
Text to Speech and Speech Recognition using an
external server
Network Attached Storage (NAS)
The Via VT6107 Ethernet controller shall be used. It
interfaces to the CPU over a 33 MHz PCI bus and connects
directly to an Ethernet RJ-45 connector with built-in
magnetic and LEDs. The RJ-45 connector pin-out is shown
in Table 6-56 Ethernet Connector Pin-Out on page
Pin No. Signal
1 Tx+
2 Tx-
3 Rx+
4 NC
5 NC
6 Rx-
7 NC
8 NC
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
6-106.
Note
10BASE-T/100BASE-TX port
(RJ-45 connector)