UNIVERGE SV8100/SV8300
System Hardware Manual
To prevent possible damage to the APR-L
UNIT or the DTL/ITL multiline terminal
during installation or removal, disconnect the
line cord/LAN cable and the AC/DC adapter
from the DTL/ITL multiline terminal.
1.
Unplug the line cord from the keyset.
2.
Turn the DTL/ITL multiline terminal upside down.
3.
Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg
Tilt Leg
Figure 11-55 Separate Tilt Leg from Leg Support
4.
Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5.
Lay the tilt leg and the leg support flat to expose APR-L UNIT
compartment.
6.
Carefully pry loose the knockout covering the bottom option
interface (refer to
Knockout on page
Support).
Figure 11-56 Bottom Option Interface
11-78).
Issue 1.0
Figure 11-55
Stoppers
11 - 77