Figure 8-46 Inserting Screws Into The Wall For Wall Mounting The Telephone - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
6.6
System Hardware Manual
Mounting the Base Directly to the Wall
If a standard wall plate is not available, mount the telephone directly on the
wall. Before mounting the telephone, consider the following:
Select a location away from electrical cables, pipes, or other items behind
the mounting location that could cause a hazard when inserting screws into
the wall.
Make sure the wall material is capable of supporting the weight of the base
unit.
Use #10 screws with anchoring devices suitable for the wall material where
the base unit will be placed.
To mount the telephone:
1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an
inch between the wall and screw heads for mounting the telephone.

Figure 8-46 Inserting Screws into the Wall for Wall Mounting the Telephone

2. Plug in and secure the AC adapter.
3. Plug the AC adapter into the base unit.
4. Plug one end of the short telephone cord into the LINE jack on the base
unit. Then plug one end of an NEC multiline telephone into the PHONE
jack. Place the telephone cords inside the molded channels on the
bottom of the wall mount stand.
Issue 1.0
8 - 37