NEC Univerge SV8100 System Hardware Manual page 639

UNIVERGE SV8100/SV8300
System Hardware Manual
3. Update Windows 2000 to Service Pack 4; this is
available as a free upgrade from the Windows
update web site.
4. When all USB Controller Cards are installed and the
PC updated, restart the PC.
5. Connect any USB hubs if applicable.
6. Once USB hubs are installed, restart the PC again.
11.5.6.3 Install the 4-Port Digital Call Logging Unit
1. Connect the 4-Port Digital Call Logging Unit device
to the USB cable and plug the USB cable into the
PC. Windows will respond with the Found New
Hardware wizard.
2. Insert the provided NEC BackOffice CD into the CD
drive of the PC.
Direct the installation of the driver to Specific
Location and specify the Driver folder on the CD.
Windows should find and load the device driver.
3. Before inserting the next USB cable, restart the
PC. If Windows responds with Found New
Hardware again, direct to the CD a second time and
restart the PC. Once you get a clean restart and
Windows recognizes the device on restart, install
the next device.
4. Leave the CD in the CD drive and connect the next
device, you may need to direct windows to the CD
with each device you connect. Also, you will need
to restart the PC with each device connection (this
may require two restarts per device).
5. Once all devices are connected, restart the PC and
view the devices in Device Manager to ensure
proper installation.
The brand or type of USB hub must match that of the
USB Controller Card.
Issue 1.0
11 - 49