NEC Univerge SV8100 System Hardware Manual page 724

Issue 1.0
13 - 12
Table 13-2 AD(A)-R Unit Switch Settings (Continued)
Switch
Dip
Switches
(DSW)
Do not connect T1 and T2 when DSW switches 3 and 4 are
On.
3.2.3 Installing the AD(A)-R Unit on a Multiline Terminal
The AD(A)-R Unit should be installed after the cables are connected
and the switches are set.
If wall mounting the Multiline Terminal, a WM-R Unit must be used. Refer to
Section 11 Wall Mounting Multiline Terminals on page
1. Unplug the telephone cord (and the AC-2R/AC-3R Unit cord if
installed) from the multiline terminal.
2. Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to
Multiline Terminal on page
Output Hook Signal to External Device
DSW 1 On = Output
Off = No Output (Default)
Record Confirmation Tone
DSW 2 On = Tone On
Off = Tone Off (Default)
DSW 3 Use T1/T2
and On = Disable (Default)
DSW 4 Off = Enable
Reset Signal Upgrade
DSW 5 On = Normal (Default)
Off = Debugging
Firmware Upgrade
DSW
On = Firmware Upgrade
6~8
Off = Disable (Default)
Figure 13-14 Attaching the AD(A)-R Unit to the
13-13.
Installing D
UNIVERGE SV8100/SV8300
Description/Settings
12-22.
term
Series i Optional Equipment